NSD NCV-20NBNVP - User Manual

Questions and Answers:

J
Jamie WilsonAug 3, 2025
What to do if there is no position data output from my NSD NCV-20NBNVP?
- J
  julieburgessAug 3, 2025
  If your NSD Media Converter isn't outputting position data, there are several potential causes: * The function setting switch may be incorrect, so try changing the setting. * The power supply voltage for input and output could be out of the prescribed range. Ensure you supply the correct power voltage (21.6V to 26.4VDC). * The external input signal “HD” might be ON; check the signal. * There may be issues with the wiring of the output signal, so repair the wiring if necessary.
T
tara38Aug 8, 2025
What to do if position data HOLD doesn’t occur on my NSD NCV-20NBNVP Media Converter?
- D
  David Ford MDAug 8, 2025
  If the position data HOLD function isn't working on your NSD Media Converter, consider the following: * The function setting switch may be incorrect, so change the setting. * The voltage of the power supply for input and output might be out of the prescribed range. Ensure the correct power voltage is supplied, which should be 21.6V to 26.4VDC. * The wiring of the input signal could be faulty, so repair the wiring.
J
Justin JonesAug 14, 2025
Why is the sensor disconnected LED (SE) ON in my NSD NCV-20NBNVP?
- J
  Julie RussellAug 14, 2025
  The sensor disconnected LED (SE) on your NSD Media Converter might be illuminated due to: * A disconnected sensor connector. Make sure to secure the connector. * A loose sensor connector. * A severed sensor cable. If this is the case, replace the sensor cable.
U
ujonesAug 20, 2025
What to do if my NSD NCV-20NBNVP Media Converter has incorrect position data output?
- C
  clarkejenniferAug 20, 2025
  If your NSD Media Converter is showing incorrect position data output, it could be due to: * Improper latch pulse output signal and position data reading timing. Correct the reading timing. * Improper HOLD input signal and position data reading timing. * Problems with the wiring of the output signal. Repair the wiring.
S
Sonya RobertsAug 27, 2025
Why is there a deviation in origin point position with my NSD NCV-20NBNVP?
- E
  erika10Aug 27, 2025
  A deviation in the origin point position on your NSD Media Converter may be caused by: * A loose coupling of the sensor shaft and machine shaft. Secure the coupling or mounting. * A loose sensor mounting.

NSD NCV-20NBNVP Specifications

General

Connector Type	SC
Wavelength	1310nm
Distance	20km
Interface	RJ45
Fiber Type	Single Mode
Data Transfer Rate	10/100/1000Base-T(X) to 1000Base-X
Humidity	5% to 95% (non-condensing)