NSD NCV-20NBNVP - Operation; Operation Sequence

8. OPERATION
8-1. Operation Sequence
START
Function selector switch setting
Designate the following setting by a switch which is at
rear face of the converter.
(1) Position data "increase direction" setting
(2) Position data reading setting
Converter mounting
Mounting the converter.
-------- Refer to section 8-2, 8-3.
-------- Refer to section 5-1.
Connect with external device
Connect ABSOCODER sensor and control devise to the
converter.
-------- Refer to section 6-1to 6-3.
Origin (position data) adjustment
Sets the current position value.
-------- Refer to section 8-4.
Test run
Check the operation. Make corrections if problems exis
t
with position data readings or current position value.
Operation
Execute operation.
END
21