●Low-speed reading (at LP=HIGH)
When low-speed reading (at LP=HIGH) is selected, the position data output stabilizes when the LP output
signal is HIGH. The position data should be read at that time.
Position data update
cycle
Switch setting
t1 t2 t3
12.8ms
12.8ms 3.2ms 6.4ms
25.6ms
25.6ms 6.4ms 12.8ms
51.2ms
51.2ms 12.8ms 25.6ms
●Low-speed reading (at LP=LOW)
When low-speed reading (at LP=LOW) is selected, the position data output stabilizes when the LP output
signal is LOW. The position data should be read at that time.
Position data update
cycle
Switch setting
t1 t2 t3
12.8ms
12.8ms 3.2ms 6.4ms
25.6ms
25.6ms 6.4ms 12.8ms
51.2ms
51.2ms 12.8ms 25.6ms
25
To Next Page
Loading...