3
INSTRUCTIONS FOR SETTING THE UNIT
Connect unit to main power source prior to entering the
settings. When powering up the unit for the first time, allow
1-2 minutes for supercap to charge and the display will
show 12 HOUR. Press reset button after 2 minutes if screen
is blank.
Press HOUR to change to 24 hour (military format) or press
ENTER to set 12 hour (AM/PM format).
NOTES:
1. During the RUN mode, the Hour, Minutes, Seconds, Day
of the week and flashing colons will be displayed.
2. The unit will not go into run mode unless the clock and
date are set. In any other mode, if no entries are made
for 5 minutes, the unit will automatically go to the run
mode.
3. Unit will display “PF” (Power Failure) in the absence of
AC power. A minimum of 8 hours is required to fully
charge the super cap.
4. When previously programmed unit comes back from a
power failure, it will “look back” and update the sched-
ule, executing the last scheduled event. Settings can be
manually updated by pressing the EVENT key in the run
mode.
After pressing ENTER the unit will display:
NOTE: AFTER MAKING ANY CHANGES TO THE PRO-
GRAM, PRESS MODE TO GO TO RUN MODE AND THEN
PRESS EVENT TO UPDATE THE LOAD STATUS.
SIG1 SIG2 CLK
DATE SCH
Reset
Location
To Next Page
Loading...
Need help?
General
