NSK FX204 M4 - Page 7

4
•Donotusethefollowingfluidstowipe,immerseorcleanthe
product;strong/superacidwater,strongacid/alkalinechemicals,
chlorine-containingsolutions,solventssuchasbenzineorthinner.
CAUTION
•Immediatelyafteratreatment,thehandpieceshouldbe
cleaned,lubricatedandsterilized.Failuretoproperlymaintain
thehandpiecemayleadtooverheating,causingburninjuriesor
productfailure.
WARNING
9-1 Preparation
1)Wearaeyeprotection,amaskandglovestoavoidinfection.
2)Disconnectthehandpiecefromthemotor.
3)Removethemotorfromthehose.
9-2 Cleaning
ManualCleaning(ExternalSurface)
1)Removedirtanddebrisonthemotorsurfaceusingabrushunder
runningwater(at38°Corless).Donotuseawirebrush.
2)Wipeoffthemoistureonthesurfaceusingabsorbentcloth.
AutomaticCleaning(ExternalandInternalSurfaces)
(OnlyforFX204mM4/FX204mB2/FX205mM4/FX205mB2)
Useathermo-disinfectorinaccordancewithISO15883(ENISO15883).
Refertothethermo-disinfectormanual.
•Afterwashingwiththermo-disinfectorandpriortolubrication,
drytheproductuntilallinternalmoistureisthoroughlyremoved.
Thermo-disinfectormoistureremaininginsidetheproductcould
reducetheeffectoflubricationandcouldcausecorrosioninside
oftheproduct.
CAUTION
9-3 Disinfection
ManualDisinfection(ExternalSurface)