What to do if NSK Surgic Pro2 shows error E1?
Error E1 on your NSK dental equipment can be caused by extended use under heavy load, a short circuit in the motor, or a motor cord failure. First, ensure the motor cord is securely re-connected, as insufficient electrical contact may be the issue. If the error persists after re-connecting the cord, request a repair.
What to do if NSK Surgic Pro2 Dental equipment shows error E2?
Error E2 on your NSK dental equipment indicates insufficient contact of the power cord or a failure of the power supply circuit. Ensure the power cord is securely re-connected. If the error continues, request a repair.
What to do if NSK Surgic Pro2 Dental equipment shows error E5?
Error E5 on your NSK dental equipment is due to abnormal voltage generated in the start/stop switch circuit or a failure in that circuit. If rotation and stop are repeated quickly, a circuit that suppresses sudden acceleration may activate. Wait a few seconds before using the equipment again. If the error persists, request a repair.
What to do if NSK Surgic Pro2 Dental equipment shows error E6?
Error E6 on your NSK dental equipment may be due to a bur or drill attachment failure, handpiece failure, or motor failure. Check that the chuck is securely closed. If the error persists, request a repair.
What to do if NSK Surgic Pro2 Dental equipment shows error E3?
Error E3 on your NSK dental equipment can be triggered by a motor sensor failure, an unplugged motor cord, a motor cord (signal line) failure, or water ingress into the motor. Make sure the motor cord is securely re-connected. Note that electrical contact may be insufficient. If the error persists, request a repair. Also, remember to attach a protection plug when cleaning in a washer-disinfector.
Why NSK Surgic Pro2 Dental equipment shows error E4?
Error E4 on your NSK dental equipment can be caused by overheating from extended use under heavy load, or using the control unit immediately after it has been exposed to high temperatures. Allow the unit to cool down before use, ensuring the periphery of the control unit is well-ventilated. If the error continues, request a repair.
General| Brand | NSK |
|---|---|
| Model | Surgic Pro2 |
| Category | Dental equipment |
| Language | English |
To Next Page
