How to fix motor rotation failure error in NSK Medical Equipment?
A 'Motor Rotation Failure Error' can occur due to handpiece attachment failure or motor failure. Check that the chuck is securely closed. If the error continues, request repair.
How to resolve a system error on NSK Medical Equipment?
A system error may be caused by a memory failure, erroneous memory, or connecting a USB flash drive other than the type stipulated (mouse, printer, etc.). Request a repair to resolve this issue.
What to do if NSK Medical Equipment shows a breaking error?
A 'Breaking Error' can occur due to abnormal voltage or failure in the start/stop switch circuit. If rotation and stop are repeated too quickly, a circuit limiting acceleration might activate. Wait a few seconds before using again. If the error persists, request a repair.
What causes motor sensor error in NSK Medical Equipment?
A motor sensor error can be caused by motor sensor failure (Hall IC), motor cord failure, or water ingress into the motor. If water has entered the motor, make sure to put a Protection Plug when Thermo-disinfecting it. Request repair.
Why am I getting a pump excess voltage error on my NSK Medical Equipment?
An excess voltage error with the pump can be due to an incorrectly fitted irrigation tube loading the pump roller, or pump failure. Check the irrigation tube. If the error persists even with a normal irrigation tube, request repair.
What to do if excessive current is detected in NSK Medical Equipment?
If you see an 'Excessive Current Detected' error, it could be due to extended use under heavy load or a short circuit in the motor. Ensure the Motor Cord is securely re-connected, as insufficient electrical contact may be the cause. If the error persists, request a repair.
Why does the NSK Medical Equipment control unit overheat?
The control unit might be overheating due to extended use under heavy load or operation in an extremely high-temperature environment. Allow the unit to cool down before resuming use. Ensure the periphery of the main Control Unit is well-ventilated. If the error persists, request repair.
Explains the function of each key on the control unit.
Details the information displayed on the control unit's LCD screen.
Memorizing and setting up 8 programs for micromotor operation.
Configuring different implant systems and their parameters.
Calibrating the handpiece for accurate torque and resistance recognition.
Step-by-step guide for normal operation of the system.
Storing and managing treatment data on a USB flash drive.
General| Motor Speed | Up to 40, 000 RPM |
|---|---|
| Display | LCD |
| Power Supply | AC power supply |
| Speed Range | 200~40, 000 min-1 |
| Rotation Speed | Up to 40, 000 RPM |
| Head Diameter | Varies depending on the handpiece |
| Light Source | LED |
| Autoclavable | Motor, Handpiece |
To Next Page
