What to do if my NSK NLZ Dental equipment is beeping when turning on?
If beeps continue to sound when turning on the switch, it may be because you are stepping on the foot pedal. Do not step on the foot pedal when turning on the power switch.
What to do if I detected over current in the circuit of my NSK NLZ?
To address an overcurrent issue, avoid overloading the handpiece with continuous heavy cutting. Press the foot pedal again to clear the error.
What to do if my NSK NLZ shows a handpiece heat generation error?
If a handpiece heat generation error is detected, perform maintenance on the handpiece and then check it using the Contra-Check.
What to do if an increasing handpiece heat generation error was detected on my NSK dental equipment?
If an increasing handpiece heat generation error is detected, perform maintenance on the handpiece, and then check the handpiece by the Contra- Check.
What to do if a motor heat generation error was detected on my NSK NLZ?
If a motor heat generation error is detected, leave the motor until it cools down.
What to do if I detected an overvoltage input to my NSK NLZ Dental equipment unit?
If an overvoltage input is detected, check the proper connection of the AC adapter and AC power cord.
Why does my NSK dental equipment handpiece water leak?
If there is water leakage, check the connection of the tubing and motor cord. If the leakage is inside the control unit, contact your Authorized NSK Dealer.
Why are the settings different when I turn on my NSK NLZ Dental equipment?
Previous settings will not be retained if the power is turned off using the main unit's power switch. Turn off the unit using the control unit’s Power Key to retain settings.
Why does the rotation speed of the motor not rise on my NSK NLZ?
If the motor's rotation speed doesn't increase, ensure the upper limit of the air pressure is set below the air pressure of the dental unit.
What to do if the LCD display of my NSK NLZ Dental equipment does not light up?
If the LCD display doesn't light up, it might be due to several reasons. First, ensure that the power switch is turned on. Next, check the connection of the AC adapter and AC power cord to make sure they are correctly connected. If these steps don't resolve the issue, and you suspect the internal fuse is blown, contact your Authorized NSK Dealer.
Lists critical safety warnings and operational precautions to prevent injury or damage.
Explains the layout and functions of the control panel and LCD display.
Step-by-step instructions for physically installing the main and control units.
Detailed instructions for connecting the tubing from the dental unit to the main unit.
Steps for properly connecting the motor cord and AC adapter to the main unit.
Procedures for connecting the AC power cord and handling motor/cord connections.
Guide to entering setup mode and customizing system functions.
Essential pre-operation checks to ensure proper function and safety.
Procedure for evaluating handpiece status and calibrating torque.
Explains built-in functions to prevent motor and handpiece overheating.
Lists all error codes, their causes, and recommended remedies.
Addresses common problems and provides step-by-step troubleshooting actions.
General| Brand | NSK |
|---|---|
| Model | NLZ |
| Category | Dental equipment |
| Language | English |
To Next Page
