What to do if my NSK NLZ E Dental equipment is beeping when turning on?
If beeps continue to sound when turning on the switch, it may be because you are stepping on the foot pedal. Do not step on the foot pedal when turning on the power switch.
What to do if I detected over current in the circuit of my NSK dental equipment?
To address an overcurrent issue, avoid overloading the handpiece with continuous heavy cutting. Press the foot pedal again to clear the error.
What to do if my NSK NLZ E shows a handpiece heat generation error?
If a handpiece heat generation error is detected, perform maintenance on the handpiece and then check it using the Contra-Check.
What to do if an increasing handpiece heat generation error was detected on my NSK NLZ E?
If an increasing handpiece heat generation error is detected, perform maintenance on the handpiece, and then check the handpiece by the Contra- Check.
What to do if a motor heat generation error was detected on my NSK dental equipment?
If a motor heat generation error is detected, leave the motor until it cools down.
What to do if I detected an overvoltage input to my NSK dental equipment unit?
If an overvoltage input is detected, check the proper connection of the AC adapter and AC power cord.
Why does my NSK NLZ E handpiece water leak?
If there is water leakage, check the connection of the tubing and motor cord. If the leakage is inside the control unit, contact your Authorized NSK Dealer.
Why are the settings different when I turn on my NSK NLZ E?
Previous settings will not be retained if the power is turned off using the main unit's power switch. Turn off the unit using the control unit’s Power Key to retain settings.
Why does the rotation speed of the motor not rise on my NSK NLZ E Dental equipment?
If the motor's rotation speed doesn't increase, ensure the upper limit of the air pressure is set below the air pressure of the dental unit.
What to do if the LCD display of my NSK NLZ E Dental equipment does not light up?
If the LCD display doesn't light up, it might be due to several reasons. First, ensure that the power switch is turned on. Next, check the connection of the AC adapter and AC power cord to make sure they are correctly connected. If these steps don't resolve the issue, and you suspect the internal fuse is blown, contact your Authorized NSK Dealer.
Lists critical safety warnings and precautions for the safe operation of the system.
Guides on the physical installation and mounting of the system components.
Details how to access and modify various system settings and parameters.
Provides essential pre-operation checks for safety and optimal performance.
Describes the operation procedure for the Rotary Endo Mode.
Details the usage of the Reciprocating Endo Mode for endodontic procedures.
Explains how to perform a handpiece status check and torque calibration.
Details the functions designed to protect the motor and handpiece from overheating.
Instructions for cleaning the motor at the point of use to minimize infection risk.
Details the process for cleaning and disinfecting the motor exterior.
Lists various error codes displayed by the system and their corresponding remedies.
Provides common troubleshooting steps for system malfunctions and abnormal behavior.
General| Type | Electric Micromotor |
|---|---|
| Model | NLZ E |
| Torque | 3.4 Ncm |
| Light | LED |
| Handpiece Connection | ISO E-type |
| Power Supply | AC 100-240V 50/60Hz |
| Protection Class | Class II |
| Speed Range | 100 - 40, 000 min⁻¹ |
To Next Page
