12
CAUTION
Make sure that each part is properly connected. Improper connections might cause faulty operation, LED lighting
failure and water or air leakage.
3-1
Installing the Main Unit and the Control Unit
1
Fix the main unit to the dental unit using the
screws. As shown below:
2
Place the control unit on the tray of the dental
unit.
M4x30, M5x30
with the nut
( included)
M4 flat head screw
( included )
3
Bundle the link cable appropriately and fix it by cable tie.
Cable tie
(included)
4
If you wish to install as shown below, optional parts are available for purchase.
( Refer to “ 9-3 Optional Parts List ” )
Installation example using
NLZ STAY
Installation example using
NLZ MOUNTING PLATE
Preparations for Use
3
To Next Page
Loading...
