Page 11 of 12
Service messages
Service message Measure
LED Dust bag (14) and ERROR “E4”
light
Dust bag is full
Replace the dust bag after 10 operating hours and clean
the hand piece.
After replacing the dust bag press the
Start/Stop pushbutton in order to be able to continue
working.
LED Service (9) and ERROR “E2” light
Service Hand-piece
After 250 operating hours the hand-piece has to be
cleaned. This corresponds to approx. 800 to 1000 foot
care treatments.
Please send the hand-piece to our customer service
department for this. If required, you can request a
replacement hand-piece.
Press the Start/Stop pushbutton (7) in order to be able
to continue working.
LED Service (9) and ERROR “E3” light
Device maintenance required
The device has to be serviced after 500 operating hours.
This corresponds to twice the number of treatments
referred to herein above.
Please send the entire device incl. the hand-piece to our
customer service department for maintenance. If
required, you can request a replacement device.
In order to be able to continue working switch off the
device with the Start/Stop pushbutton (7) and switch on
once again.
As long as no device maintenance happened, this
procedure must be repeated at every switching on the
device.
Please remember: If the maintenance intervals are exceeded by more than 15 per cent, the warranty
and liability of the manufacturer cease to apply.
Technical data
Product number: 9160.4
Operating voltage: 230 V ~ / 50/60 Hz or 100/110 V ~ / 50/60 Hz
Power consumption:
350 W
Speed: 5000 – 30000 rev./min
Safety fuse: 2 x 1.6 A T or 2 x 3,15 A (110 V)
Protection class: I
Ambient conditions: temperature between +10 °C and +30 °C
storage temperature between +5 °C and +40 °C
relative air humidity between 20 % and 65 %
Dimensions (WxHxD): 286 x 130 x 237 mm
Weight of hand-piece:
150 g
Weight of device incl. hand-piece set:
3.5 kg
Scope of delivery: 1 device incl. hand-piece, 2 dust-bags and mains cable
Accessories: foot switch, grinder, set of dust-bags (5 pcs.)
To Next Page
Loading...
