Data Log Viewer
PDF MANUAL
Press the operating
key to turn on the
power.
Press and hold the
operating key.
“PA” is displayed. The control unit makes a beep and then “OK” will
appear. Pairing is done. Make sure that the device is
connected.
Press the CANCEL
Key to return to
the normal screen.
Turn on the power. Press and hold the
button.
When the LED turns blue,
release the button.
The control unit makes a beep and then “OK” will appear.
Pairing is done. Make sure that the device is connected.
Also the LED of link module turns green.
Press the CANCEL
Key to return to
the normal screen.
Launch the App.
Install the App beforehand.
Touch the icon. Touch ”Start ”. Enter the code
“123456” and touch
“Pair”.
Press the CANCEL
Key to return to
the normal screen.
The control unit makes a beep and then ”OK”
will appear. Pairing is done. Make sure that
the device is connected.
www.nsk-dental.com/qr/app-surgicpro2
Osseo 100+
Foot control
VarioSurg3
External terminal
×2
Press the CANCEL
Key to return to
the normal screen.
Press the ENTER
Key.
Press and hold the
Left and Right buttons
and the pedal at the
same time.
The control unit makes a beep and then "OK" will
appear. Pairing is done. Make sure that the device is
connected.
×2
Connected
Connected
Power ON
At least
3 sec.
×2
×2
The first step after purchase
（
Pairing with each device
）
This operation is not necessary
when using Surgic Pro2 for the
first time after purchase.
If the foot control is unpaired or
when using another foot control
newly purchased, conduct the
following operation.
NOTICE : Paring can be done
within 10 minutes after inserting
the battery.
Connected
Approx. 10 sec.
Press and hold the
SETTING Key.
“BLE SET” is displayed.
At least 2 sec.
Press the ENTER
Key.
Press the TORQUE Key to select the device.
NOTICE : The letters on the screen except “BLE SET”
and “PAIRING” flash on and off.
Foot control
Osseo 100+
VarioSurg3
External terminal
Press the ENTER Key.
1
2 3
Connected
Connect the link
cable beforehand.
20XX.XX.XX XXX
To Previous Page
Loading...
