12
7-5 Lubrication
NSK PANA SPRAY Plus / PANA SPRAY
Apply NSK PANA SPRAY Plus / PANA SPRAY every time after each use and/or before autoclaving.
1) Attach the CORRECT Spray Nozzle onto the spray port nozzle on the can.
2) Insert the Spray Nozzle into the rear of the handpiece. Hold the handpiece and spray for approximately
2-3 seconds. Apply lubricant until it expels from the handpiece head for at least 2 seconds (Fig. 7).
CAUTION
• Hold the spray can upright.
• Firmly hold the handpiece to prevent it slipping when spray pressure is applied.
• Spray lubricant until it expels from the handpiece head.
E-Type Spray
Nozzle
Handpiece
Fig. 7
To Next Page
Loading...
Need help?
General
