4
CAUTION
• Do not exceed Max. Bur Length shown in "9. Specifications".
• Always follow the instructions provided by the bur manufacturer.
• Do not exceed the bur speed recommended by the bur manufacturer.
• Should the handpiece function abnormally during use, stop using the handpiece immediately and contact your Authorized NSK Dealer.
• Do not use the following fluids to wipe, immerse or clean the product; st
rong/super acid water, strong acid/alkaline chemicals, chlorine-
containing solutions, solvents such as benzine or thinner.
• The handpiece is delivered in a non-sterile condition and must be autoclaved prior to use.
• Perform regular function and maintenance checks. (Refer to "8. Periodical Maintenance Checks")
• If the handpiece has not been used for a long period, rotate the handpiece and check for
noise, vibration and overheating before use.
• To avoid clinical downtime it is recommended that a spare be kept on hand in case of a breakdown during treatment.
• The operation of the handpiece is permitted only on dental units which correspond to the standards IEC 60601-1 (EN 60601-1) and IEC 60601-1-2 (EN 60601-1-2).
• U.S. Federal law restricts this device to sale by or on the order of a licensed physician.
X85L / X85
• Use a short shank FG bur for the product because the handpiece has the miniature head. Using a long bur with this handpiece may lead to
premature abrasion of the bearings. In addition, sudden release, bend or breakage of the bur may occur.
X95L / X95
• Do not use a surgical bur with its maximum length of 25mm or longer. Using such bur with this handpiece may lead to premature abrasion of
the b
earings. In addition, sudden release, bend or breakage of the bur may occur.
To Next Page
Loading...
Need help?
General
