Check before use
Product Storage and Care
How to Store and Clean after Use Self-check Items
1. Is the power cord connected to an outlet?
2. Are lights on the power lamp and indication
window turned on when the power supply is
applied?
3. Is the temperature indication displayed on the
temperature indicator window on the controller?
4. Is the temperature increasing well in the
product?
5. Is the temperature in the product not too high?
6. Did you check out conditions for any damage
to the power cord or cable conditions?
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Check after use
· During operations: temperature (0~35), humidity (20~80%)
· Transport and storage conditions: temperature (-25~70),
humidity (20~80%), atmospheric pressure (700hPa to 1060hPa)
Caution
Remove the power plug before cleaning
There might be a danger of electric shocks.
Environmental conditions
How to clean
Controller
Wipe it out with a piece
of dry cloth if there is
any foreign substance.
Product top
Wipe it out with wax
for leather or dry cloth.
Caution
There might be a danger of injuries or fire if you fail to check out the
following. Please make sure that your check them out.
NM-200
Yes No
Yes No
Yes No
Yes No
1. Is the temperature on the temperature indicator
window on the controller turned off?
2. Are lights on the power lamp and indicator
window turned off?
3. Is the power cord removed from the outlet?
4. Is the place to keep the product exposed to
the humidity dust and/or chemicals?
Introduction
1. Separate the power cord while the product is not in use for a long time.
2. Be aware of the following for the storage place.
ྙ Keep the product in a place with no water.
ྚ Keep the product in a place with no concern of any adverse effect such
as the air pressure, temperature, humidity, ventilation, sunlight and/or
air containing dust, salt, sulfur, etc.
ྛ Be careful of safety conditions such as the slope, vibration, shock, etc.
(including those during transportation).
ྜ Do not keep the product in a place near any chemical or gas.
ྜྷ Avoid any direct sunlight during the storage.
3. Store the product after cleaning the components.
i
To Next Page
Loading...
