EasyManua.ls Logo

Nuga NM-5000 - Manual & External Projector Modes

Nuga NM-5000
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AUTO MANU
AUTO MANU
TEMP
MANUAL
TEMP
MANUAL
N
U
G
A
B
E
S
T
AUTO
PJT L/F
MANU
TEMP
TEMP
Min Max
Mid
CONT
MANUAL
PROJECTOR
LOW FREQ
PROJECTOR
LOW FREQ
PROJECTOR
LOW FREQ
POWER
AUTO
N
U
G
A
B
E
S
T
AUTO
PJT L/F
MANU
TEMP
TEMP
Min Max
Mid
CONT
MANUAL
PJT L/F
TEMP
Min Max
Mid
CONT
PJT L/F
TEMP
Min Max
Mid
CONT
Temperature control
AUTO MANU
TEMP
MANUAL
How to Use the Remote Controller
- How to Use the External Projector
Applied to the specific area
Caution
Apply to the desired area.
· Put the projector covers on before
applying it.
Ensure the projector covers to
be covered while the external
projector is being used.
· Be aware that any direct contact
from the projector to the skin during
the high temperature setting might
cause burns.
Press the projector button.
· Check out the connecting conditions
of the projector.
· Press the projector button once: On
Press it once again: Off
Operations
Temperature control
Control temperature with +/- button.
(Moderate temperature: 55~60)
· The projector is not turned on of the
actual temperature is higher than the
setting temperature, which is not meant
to be any failure.
· Temperature setting unit
40~55: Temperature setting per 5
55~70: Temperature setting per 1
Manual Mode
Manual Mode
Use the product after placing the
internal projector at the desired
position with manual button
ŸźGXULQJWKHPDQXDOPRGH
The internal projector moves
ZKLOHŸźLVEHLQJSUHVVHG
Ÿ7KHLQWHUQDOSURMHFWRUPRYHV
to the cervical vertebrae.
ź7KHLQWHUQDOSURMHFWRUPRYHV
to the vertebrae lumbales.
Press the power button.
· Check out the connecting conditions
of the remote controller.
· Press the power button once : On
Press it once again : Off
Power supply

NM-5000

PROJECTOR
LOW FREQ
POWER
AUTO
POWER
AUTO
POWER
AUTO
POWER
AUTO
.PWJOH
QBUI
Control temperature with +/- button.
(Moderate temperature: 55~60)
· Range of temperature setting for
internal projector: 40~70
· Temperature setting unit
40~55: Temperature setting per 5
55~70: Temperature setting per 1
How to Use the Product

Related product manuals