Nuga NM-5000 - Names and Functions of Product Components

Names and Functions of
Product Components
The sub heater positioned on top of the sub mat increases the heating
effects by combining the tourmanium mat.
ⴙ Sub heater
Temperature can be set by turning a dial to the desired position.
ⴛ Temperature setter for
sub heater
A remote controller, external projector and low frequency pad are connected
to the main assembly.
ⴜ Connector bay
Low frequency pad has various functions including the relief from pain, etc.
ⴚ Low frequency pad
Both the main mat and sub mat are horizontally built, which can be used
more conveniently with the attachment of a handle to be
controlled in step
UHVSHFWLYHO\IRUWKHGHVLUHGDQJOHRIÛÛRUÛ
Ceramics are separately built in around the cervical vertebrae as the
acupressure load can be equally distributed due to the design that the internal
projector can be rotated in a certain angle to the up/down/left/right. In addition,
there are few noises thanks to the minimized friction between the internal
projector and rail due to the specially designed guard rail which can be used
semi-permanently by minimizing the driving load.
ⴟ Product frame
ⴠ Internal projector
External projector is designed in a size conveniently held and used with
a hand, which can be stored in a projector pocket nicely during no use.
ⴝ External projector
and projector pocket
Buttons in a size that can be identified at a glance are easy to use and
button descriptions cannot be easily erased due to the use of special
PDWHULDOV,QDGGLWLRQWKHUHPRWHFRQWUROOHUKROGHUSRVVLEOHRIÛURWDWLRQ
can be used conveniently in any desired angle by the user.
ⴞ Remote controller and
its holder
Name Function
The connection for the
power supply on the main
assembly and the power
input to the special heater
ྙ
ྡ Internal projector
ⴘ The connection for the power
supply on the main assembly
and the power input to the
special heater
ྞ External projector
and projector pocket
ྛ Low frequency pad
ྜ Temperature setter
for sub heater
ྚ Sub heater
The power supply and signals are exchanged by connecting the power
supply cable to both the main mat and sub mat.
ྜྷ Connector bay
ྟ Remote controller and its holder
ྠ Product frame

NM-5000

HIGH
LOW
Product Introduction