Nuga T9 - Before any A;S Request; Check Indicator Window of Controller

Checklist for any abnormality in the power supply
Checklist for any abnormality in the heating
If the temperature is
not increasing
in the product;
ⴘ Check out if the power plug on the controller
is connected to an outlet.
ⴙ Check out if the power button in the controller
is pressed to turn on the product.
ⴚ Check the operating voltage.
ⴘ Check out if the power button in the
controller is pressed to turn on the
product.
ⴙ Check out if the temperature is set to too
weak.
ⴚ Do not disassemble the product but
contact your supplier or our company.
 
If there is no power
supply on the
power lamp;
T9
Before any A/S request Check Indicator Window of Controller
Product Storage and Care
Caution
Ensure checking out the followings before applying for A/S if any
abnormality occurs in the product.
The product might fail to operate normally even without any failure if
you use it without reading the manual.
Caution
Do not disassemble the product arbitrarily if any error occurs, but
remove the power plug, turn off the power switch, and then contact
your supplier.
If you disassemble the product arbitrarily, it might cause serious
injuries and/or damage to the product.
Disconnection of
temperature sensor
Overheating in
heating material
Temperature
Indicator
Window (FND)
Short circuit of
temperature sensor
Temperature
Indicator
Window (FND)
Temperature
Indicator
Window (FND)
Internally overheated
Temperature
Indicator
Window (FND)
Display Descriptions Display location