MEGAWATT CARBON BIKE MANUAL | 2 9
HOW TO SET UP YOUR FRONT SAG
You will need to set-up front sag to balance the bikes suspension with the rear sag. Front sag will be your base setting and
with use you can adjust the sag to suit rider preference, riding style and terrain.
For Front suspension, consult the chart on the back of the
fork leg to find your recommended air pressure settings,
this will be based on rider kitted weight.
To add or remove air, remove the valve cap from the fork
and set aside.
Screw the shock pump on until the pressure gauge shows
a PSI reading. Use the pump to add or remove air until the
gauge matches the recommended setting.
Cycle the fork through its travel a few times to balance
the positive and negative chambers. Push the fork up and
down to balance.
Once the desired pressure is achieved, unscrew the
shock pump carefully to ensure no pressure is lost from
the fork.
Re-fit the valve cap to the fork.
To Next Page
Loading...
