EasyManua.ls Logo

Nukeproof MEGAWATT - Section 11: Warnings; Minimum Seat Post Insertion; Tyre and Fork Limitations; Rider Weight Limitations

Nukeproof MEGAWATT
71 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MEGAWATT CARBON BIKE MANUAL | 6 5
SECTION 11 - WARNINGS
MINIMUM SEAT POST INSERTION
The seat post installed to your bike will have a minimum insert line, do not exceed this line. Exceeding the minimum insert
can lead to post and frame damage. If you need the saddle higher than the insert level allows, please consult with your
dealer regarding frame sizing or a longer post. Damage to a seat post or frame caused by not adhering to the minimum
insert line is not covered by warranty.
MAXIMUM TYRE WIDTH
Do not exceed the fork and frame maximum tyre widths. The frame is designed to accept a tyre up to 2.6’’ and the fork’s
maximum tyre widths are detailed below. Please note some manufacturer tyre and rim combinations can be wider when
fitted together, always check for clearance when tyres are changed to a different model. Tyre rub can damage frame and
will not be covered by warranty if incorrect tyre size has been used.
RockShox ZEB max tyre clearance 2.8’’
MAXIMUM AXLE TO CROWN AND TRAVEL OF FORK
The fork length also detailed as axle-to-crown (A-C) cannot be exceeded. Maximum A-C for the Megawatt Carbon is 596mm.
Using a fork that exceeds the A-C may lead to frame failure and injury. Using a longer axle to crown fork will void warranty.
The bike is designed with a 170mm fork in mind, though a 180mm fork can be used as long as the A-C is not exceeded. A dual
crown/triple clamp fork cannot be installed to the Megawatt Carbon.
DIRECT SUNLIGHT AND HEAT
Try to avoid exposing your bike to direct sunlight and excessive heat, this can damage the paint and fatigue plastic
components.
RIDER WEIGHT
Nukeproof bikes are designed and tested to ISO 4210 / EN17404 standards. Our bikes conform to the load tolerance of
120kg the standards require. If the user is over this weight when kitted, we would recommend regular inspection and
maintenance to avoid issues and expect wear and tear parts to be replaced more often. Third-party components may have
different load and weight standards, any concerns with components weight limits please consult with your Nukeproof
Dealer. We cannot guarantee the integrity of the bike and its components if the user is over 120kg.

Related product manuals