CD PLAYER QUICK SETUP (ENGLISH)
1. Make sure all items listed on the front of
this guide were in the box.
2. READ SAFETY INSTRUCTION BOOKLET
BEFORE USING THE PRODUCT.
3. Assemble unit following the Quick
Assembly Instructions.
4. Study this setup diagram.
5. Place the unit in an appropriate position for
operation.
6. Make sure all devices are turned off and all
faders and gain knobs are set to “zero”
7. Connect all stereo input sources as
indicated in the diagram, your microphone,
and headphones
8. Connect the stereo outputs to power
amplifier(s), tape decks, and/or other audio
sources.
9. Plug all devices into AC power.
10. Switch everything on in the following order.
• audio sources (i.e. turntables or CD
players)
• mixer
• last, any amplifiers or output devices
11. When turning off, always reverse this
operation by,
• turning off amplifiers
• mixer
• last, any audio sources
12. Go to http://www.numark.com for product
registration.
More information about this product may be
found at http://www.numark.com
To Next Page
Loading...
Need help?
General
