EasyManuals Logo

Numatic NX300 Instructions

Numatic NX300
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
13
Notes
B
A
Daily
Keep the machine clean.
Ensure brushes / pads / squeegee / lters are in good condition.
Check for any worn or damaged parts and replace immediately.
Drain and rinse dirty water tank after every use.
Weekly – as daily and –
Check brush / pad and deck skirt, wipe and rinse.
Check oor tool blades for wear and wipe clean.
Clean separator assembly including lter and check condition of seal.
Flush out system with clean water and clean lters.
TwinTec
Maintenance
Remove the tank assembly from the front of the machine using the inset handle on the front of the tank assembly, lift the tank
assembly straight up (A).
Pull the tank assembly from the machine and place on the ground.
The battery can then be lifted from the machine for storage or charging using the handle on the battery (B).
For information relating to the operation and charging of your battery please refer to the battery and charger original operating
instructions.
Batttery Removal and Charging
Removing the battery

Table of Contents

Other manuals for Numatic NX300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Numatic NX300 and is the answer not in the manual?

Numatic NX300 Specifications

General IconGeneral
BrandNumatic
ModelNX300
CategoryScrubber
LanguageEnglish

Related product manuals