4002 non-addressable control and indicating equipment
User Manual
3
32-0015-r07_2018-03
© 2015 ~ 2018 Ambest Electronics (Ningbo) Co Ltd. All rights reserved.
All specifications and other information shown were current at the date of publication and subject to change without notice.
2.2.1. Enter Access Level 2
To enter the Access Level 2 passcode, take the following actions:
1) Press and hold the ACKNOWLEDGE button for 3 s. The SUPPLY LED will flash rapidly.
2) Enter the Access Level 2 passcode using the buttons numbered 1 ~ 8. Each button press will cause the
following indicator to light:
First button press
Zone 1 TEST FAULT DISABLED
Second button press
Zone 2 TEST FAULT DISABLED
Third button press
Zone 3 TEST FAULT DISABLED
Forth button press
Zone 4 TEST FAULT DISABLED
3) Press ACKNOWLEDGE button to confirm the passcode (Note: The ACKNOWLEDGE LED does not flash
during this process).
If the passcode is correct:
The internal sounder will give a double short beep.
The SUPPLY LED will flash twice, pause, then repeat.
If the passcode is incorrect:
The internal sounder will give a single long beep.
The Zone indicators will turn off.
A new passcode can be entered.
To exit Access Level 2, press RESET.
2.2.2. Change Access Level 2 Passcode
The Access Level 2 passcode may be changed from the factory default setting. The Access Level 2 passcode
cannot be the same as the Access Level 3 passcode.
To change the passcode, take the following actions:
1) Enter Access Level 3.
2) Press and hold the ACKNOWLEDGE button for 10 s. The SUPPLY LED will flash rapidly.
3) Press 2. The ACKNOWLEDGE LED and the DELAYS ACTIVE LED will both flash.
4) Press ACKNOWLEDGE button. The ACKNOWLEDGE LED will be off and the DELAYS ACTIVE LED will
illuminate.
5) Enter the new 4-digit Access Level 2 passcode using the buttons numbered 1 ~ 8. Each button press will
cause the following indicators to light:
First button press
Zone 1 TEST FAULT DISABLED
Second button press
Zone 2 TEST FAULT DISABLED
Third button press
Zone 3 TEST FAULT DISABLED
Fourth button press
Zone 4 TEST FAULT DISABLED
6) Press ACKNOWLEDGE button to confirm the passcode.
Note: The ACKNOWLEDGE LED does not flash during this process unless more than 4 passcode numbers
are input.
7) Repeat Steps 5 and 6 to confirm the passcode. The internal sounder will give a double short beep.
Passcode is now changed.
Access Level 2 can only be entered if there are no new events to acknowledge.
The factory default Access Level 2 passcode is 6688.
To Next Page
Loading...