Numens 4002 - Access Levels; Access Level 1; Access Level 2

4002 non-addressable control and indicating equipment
User Manual
2 32-0015-r06_2018-03
© 2015 ~ 2018 Ambest Electronics (Ningbo) Co Ltd. All rights reserved.
All specifications and other information shown were current at the date of publication and subject to change without notice.
DISABLEMENTS
SELECTED ZONES Selects specific detection zones for disablement. Used in conjunction with Zone
buttons and SILENCE/ACTIVATE ALARMS button. The indicator is active when
disablements are active.
DELAYS ACTIVE Disables and enables delays of configured alarm devices. When the indicator is
on, the delay is active. Pressing the DELAYS ACTIVE button over-rides the
delays and causes immediate actions.
ALARM ZONES Disables and enables alarm devices. When the indicator is active, the alarm
devices are disabled.
AUXILIARY
OUTPUTS
Disables and enables relay outputs. When the indicator is active, the output
devices are disabled.
CONTROLS
ACKNOWLEDGE
Acknowledges a new Alarm or Fault event and silences the internal sounder. The
LED will illuminate when a new Condition occurs.
RESET Resets the fire detection and alarm system.
INDICATOR TEST Illuminates all LEDs and activates the internal sounder.
SILENCE/ACTIVATE
ALARMS
Activates audio/visual alarm devices. The LED illuminates when the alarm devices
are active.
The DISABLEMENTS and CONTROLS buttons are number 1 ~ 8. These buttons are also used to enter
Access Levels 2 and 3.
2. ACCESS LEVELS
Three access levels are used to operate or configure the control and indicating equipment.
2.1. Access Level 1
Access Level 1 provides open access to perform the following functions:
 Acknowledge a new event (and silence the internal sounder).
 Override any active delays in the Alarm Condition.
 Perform the indicator test.
 Place the panel into Access Level 2 or Access Level 3.
 Reset to factory default settings.
2.2. Access Level 2
Access Level 2 provides access to functions for authorized users:
 Acknowledge a new event (and silence the internal sounder).
 Override any active delays.
 Perform the indicator test.
 Silence and re-active alarms (including for a building evacuation).
 Reset the fire detection and alarm system.
 Disable or enable the following:
o Zones
o Alarms
o Auxiliary outputs
 Active delays (if configured).