Numens 4002 - Access Level 3

4002 non-addressable control and indicating equipment
User Manual
4 32-0015-r06_2018-03
© 2015 ~ 2018 Ambest Electronics (Ningbo) Co Ltd. All rights reserved.
All specifications and other information shown were current at the date of publication and subject to change without notice.
If the two passcodes entered are different:
 The internal sounder will give a single long beep.
 The Zone indicators will turn off.
 A new passcode can be entered.
2.3. Access Level 3
Access Level 3 is used to configure the control and indicating equipment and accesses the following functions.
 Configuration of coincidence detection
 Setting delay timer.
 System Test.
 Setting delays.
 Configuring non-latching Zones.
 Change Access Level passcodes.
2.3.1. Enter Access Level 3
To enter the Access Level 3 passcode, take the following actions:
1) Press and hold the ACKNOWLEDGE button for 3 s. The SUPPLY LED will flash rapidly.
2) Enter the Access Level 2 passcode using the buttons numbered 1 ~ 8. Each button press will cause the
following indicator to light:
First button press
Zone 1 TEST FAULT DISABLED
Second button press
Zone 2 TEST FAULT DISABLED
Third button press
Zone 3 TEST FAULT DISABLED
Forth button press
Zone 4 TEST FAULT DISABLED
3) Press ACKNOWLEDGE button to confirm the passcode (Note: The ACKNOWLEDGE LED does not flash
during this process).
If the passcode is correct:
 The internal sounder will give a double short beep.
 The SUPPLY LED will flash three times, pause, then repeat.
If the passcode is incorrect:
 The internal sounder will give a single long beep.
 The Zone indicators will turn off.
 A new passcode can be entered.
To exit Access Level 3, press RESET.
Changes made at Access Level 3 affect the factory default settings and the operation of
the system. Changes should only be made by qualified personnel who are fully aware of
the effects.
The factory default Access Level 3 passcode is 8765.
If an Alarm Condition or Fault Condition occurs when in Access Level 3, the control and
indicating equipment will automatically revert to Access Level 2.