Nuna Exec User Manual

Head Insert Use
1
- The head insert may be used or removed for
improved comfort or fit of any child. To use,
attach the snaps on the head insert to the
snaps on the head support.
2 - When the head insert is not in use, tuck the
snaps on the head support behind the head
support fabric.
Infant Insert Use
The infant insert MUST be used for a child
weighing between 5–11 lb and must NOT be used
otherwise. The insert can improve the harness fit
and recline angle for smaller infants.
When rear facing, the harness MUST be positioned
AT or JUST BELOW the child's shoulders. If the
harness straps are positioned ABOVE the child's
shoulders, use the infant insert to adjust the fit.
3 - Pull harness buckle up through slot in bottom
of insert.
4 - Route harness straps through sides of insert.
5 - Attach snaps on insert to keep harness straps
in place.
6 - Push insert firmly into child restraint.
When properly installed, the infant insert will
not interfere with harness straps or harness
buckle. Harness buckle must be used in inner
position when infant insert is used (p.28).
6
24
EXEC
™
instructions
1
2
25
EXEC
™
instructions
3
4
5

Nuna Exec Specifications

General

Recline positions	8 positions
Adjustable headrest	Yes
Orientation	Rear-facing and forward-facing
Safety features	Side-impact protection, energy-absorbing foam
Product Weight	26.6 lbs
Expiration	10 years
Safety Standards	FMVSS 213 certified
Installation method	Belt path, LATCH