Using Vehicle Lap/Shoulder Belt
(preferred installation method)
1 - Route vehicle lap/shoulder belt through BLUE
rear facing belt path and buckle vehicle lap/
shoulder belt. Vehicle belt MUST be routed
under True Tension
™
door (1).
Remove all slack from the vehicle belt (2).
2 - Close True Tension
™
door and lock vehicle belt
(refer to vehicle owner's manual). Test by pulling
on shoulder belt to ensure it is locked.
Replace seat cover and infant insert (if used).
To open True Tension
™
door, unbuckle vehicle belt
and lift door release button.
Check Installation
Seat is in rear facing recline position.
Leg rest is locked and making contact with the
vehicle seat, positioned at the same angle as the
vehicle seat back.
Seat is securely installed. Hold seat near rear-
facing belt path and move seat in all directions.
Seat should move less than 1 inch.
Tether strap is not used for rear facing installation
and must be secured in storage location on back
of child restraint.
Cup holders may be placed in any position after
installation.
WARNING: Check that child restraint is
securely installed before each use.
1
2
1
2
44
EXEC
™
instructions
45
EXEC
™
instructions
To Next Page
Loading...
Need help?
General
