Using Vehicle Lap Belt
1
- Route vehicle lap belt through BLUE rear facing
belt path and buckle vehicle lap belt (1).
Remove all slack from vehicle lap belt (2).
2 - Close True Tension
™
door and lock vehicle belt
(refer to vehicle owner's manual). Test by pulling
on lap belt to ensure it is locked.
Replace seat cover and infant insert (if used).
To open True Tension
™
door, unbuckle vehicle belt
and lift door release button.
Check Installation
Seat is in rear facing recline position.
Leg rest CANNOT be extended. It is locked and
making contact with the vehicle seat, positioned
at the same angle as the vehicle seat back.
Seat is securely installed. Hold seat near rear
facing belt path and move seat in all directions.
Seat should move less than 1 inch.
Tether strap is not used for rear facing installation
and must be secured in storage location on back
of child restraint.
Cup holders may be placed in any position after
installation.
WARNING: Check that child restraint is
securely installed before each use.
WARNING: In this installation, the leg rest
CANNOT be extended (must be pushed as far
back into the child restraint as possible).
48
EXEC
™
instructions
1
49
EXEC™ instructions
2
1
2
To Next Page
Loading...
Need help?
General
