Using Vehicle Lap/Shoulder Belt
(preferred installation method)
1 - Route vehicle lap/shoulder belt through RED
forward facing belt path and buckle vehicle lap/
shoulder belt (1). Vehicle belt MUST be routed
under True Tension
™
door.
Remove all slack from the vehicle belt (2).
Close True Tension
™
door (3). Lock vehicle belt
(refer to vehicle owner's manual). Test by pulling
on shoulder belt to ensure it is locked.
Replace seat cover.
2 - Attach tether hook to tether anchor on vehicle
(p.38).
3 - Tighten by pulling on tether strap to remove
all slack.
Tuck excess webbing behind child restraint.
To open True Tension
™
door, unbuckle vehicle belt
and lift door release button.
Check Installation
Seat is in forward facing recline position.
Seat is securely installed. Hold seat near
forward facing belt path and move seat side to
side, front to back, and up and down. Seat should
move less than 1 inch.
Tether is properly used and attached to vehicle
tether anchor.
WARNING: Check that child restraint is
securely installed before each use.
2
1
52
EXEC
™
instructions
1
2
3
53
EXEC
™
instructions
3
To Next Page
Loading...
