Using Lower Anchor Belt
1
- Remove lower anchor belt from storage
compartment (p.36) and route through RED
forward facing belt path. Belt MUST be routed
under True Tension
™
door.
2 - Lengthen lower anchor belt as necessary and
attach to lower anchor points in vehicle.
3 - Remove all slack from lower anchor belt by
pulling loop at end of belt straight back from
lower anchor connector (1).
Close True Tension
™
door (2). Replace seat cover.
4 - Attach tether hook to tether anchor on vehicle
and tighten (p.38).
Tuck excess webbing behind child restraint.
To open True Tension
™
door, release tether and lower
anchors. If needed, slightly push child restraint against
vehicle seat to relieve tension on lower anchor belt
before releasing anchors. Lift door release button.
Check Installation
Seat is in forward facing recline position.
Seat is securely installed. Hold seat near
forward facing belt path and move seat side to
side, front to back, and up and down. Seat should
move less than 1 inch.
Tether is properly used and attached to vehicle
tether anchor.
WARNING: Do not install by this method for
a child weighing more than 40 lb (18.1 kg).
4
54
WARNING: Check that child restraint is
securely installed before each use.
EXEC
™
instructions
1
2
3
55
EXEC
™
instructions
1
2
To Next Page
Loading...
Need help?
General
