Using Vehicle Lap Belt
1 - Route vehicle lap belt through RED forward
facing belt path and buckle vehicle lap belt.
(1) Vehicle belt MUST be routed under True
Tension
™
door.
Remove all slack from the vehicle lap belt to
properly secure the child restraint (2).
Close True Tension
™
door (3). Lock vehicle
belt (refer to vehicle owner's manual). Test by
pulling on lap belt to ensure it is locked.
Replace seat cover.
2 - Attach tether hook to tether anchor on vehicle
(p.38).
3 - Tighten by pulling on tether strap to remove
all slack.
Tuck excess webbing behind child restraint.
To open True Tension
™
door, unbuckle vehicle belt
and lift door release button.
Check Installation
Seat is in forward facing recline position.
Seat is securely installed. Hold seat near
forward facing belt path and move seat side
to side, front to back, and up and down. Seat
should move less than 1 inch.
Tether is properly used and attached to vehicle
tether anchor.
WARNING: Check that child restraint is
securely installed before each use.
2
1
56
EXEC
™
instructions
1
57
2
3
EXEC
™
instructions
3
To Next Page
Loading...
