Nuna mixx Series User Manual

10
MIXX series bassinet instructions
11
MIXX series bassinet instructions
Product Set Up
Support Mounts
1 - Remove the mattress pad and rotate the attachment
mounts out from the center of the bassinet.
2 - Unfasten the hook and loop strips and lift the fabric
away from inside the bassinet to access the two support
mounts, which are located under the fabric at the
canopy and foot ends of the bassinet.
3 - Holding the top rail of the foot end, push the support
mount back to raise the end of the bassinet.
4 - Rotate the support mount down towards the latch at the
bottom of the bassinet as shown.
5 - Push the support mount into the latch on the bottom of
bassinet until it clicks into place. Repeat on the canopy
end of the bassinet.
6 - To fold, push button on the latch and pull support mount
out.
2
1
3
4
5
6
click

Nuna mixx Series Specifications

General

Weight capacity	50 lbs
Suspension	All-wheel suspension
Maximum child weight	50 lbs
Frame material	Aluminum
Harness type	5-point
Car seat compatibility	Nuna PIPA series
Stroller width	23.6"
Folded width	23.6"
Seat facing directions	Parent-facing, World-facing
Compatibility	Nuna PIPA series