Installation
1 - WARNING Serious injury
or death can occur. The seat alone cannot be
installed in the vehicle. It must be installed
with the base.
Installation in an Aircraft
When used with the base, This Restraint is
Certified for Use in Motor Vehicles and Aircraft.
Install the base on an aircraft by following the section
Installation Using Lap and Lap/Shoulder Belt on
page 36. It may be necessary to shorten the lap
belt by twisting it, to achieve a proper installation.
Installation on a Stroller
This infant carrier can attach to Nuna strollers as
well as other brands of strollers using adapters.
Please visit nuna.eu
/caen
for more information.
Base Installation Using Rigid UAS
(Lower Attachments)
2
- Place vehicle in park and on level ground
Position base in a forward facing vehicle seat.
3 - If necessary, install rigid UAS guides on
vehicle UAS lower anchor bars.
4 - Rotate rigid UAS (lower attachments) down.
5 - Hook rigid UAS (lower attachments) onto
vehicle UAS lower anchor bars.
6 - Confirm proper installation by pulling on the
base AND also seeing that green is indicated
on the connectors.
The rigid UAS (lower attachments) must be
attached and locked onto the vehicle anchor bars.
32 PIPA lite instructions
To Next Page
Loading...
Need help?
General
