Nuna Pipa lite User Manual

Base Installation Using Lap and
Lap/Shoulder Belt
1
- Place vehicle in park and on level ground.
Position base in a forward facing vehicle seat.
2 - Open the vehicle belt lock off by lifting up.
3 - Route the vehicle belt through the opening
in the base labeled ‘belt here’ and under the
vehicle belt lock off.
4 - Buckle the vehicle belt. Both the shoulder
AND lap belt must be under the vehicle belt
lock off and belts must lay flat. If necessary,
adjust the angle of the base. A rolled up towel
or foam pool noodle may be used to help
adjust the amount of recline. Angle is correct
when blue line on carrier is levelled with
ground.
5 - While pressing the base into the vehicle seat
(1), tighten the vehicle belt by pulling straight
along the belt path (2).
6 - While the shoulder belt is tight, hook the
bottom of the vehicle belt lock off (1) and press
to close (2). If vehicle only has a lap belt, then
put lap belt under vehicle belt lock off.
36 PIPA lite series instructions

Nuna Pipa lite Specifications

General

Weight Capacity	4 to 32 lbs
Height Capacity	Up to 32 inches
Weight	5.3 lbs
Safety Features	Side impact protection
Compatibility	Nuna strollers
Safety Standards	FMVSS 213
Infant Insert	Included
Canopy	UPF 50+ canopy
Harness Slots	5-point harness