1 - Option 1: Route the vehicle lap belt under both
lap belt guides and buckle the vehicle belt.
Allow shoulder belt to lay against vehicle seat
back as shown.
2 - Option 2: Route the shoulder belt around the
back of the child restraint passing through the
blue shoulder belt guide.
3 - Option 3: If your vehicle does not have a
shoulder belt, the lap belt only can be used.
4 - Adjust the angle of the child restraint. A rolled
up towel or foam pool noodle may be used to
help adjust the amount of recline.
5 - Angle is correct when blue line on child
restraint (located on the label on the side of the
child restraint) is level with ground.
6 - Tighten vehicle belt while pushing child
restraint firmly into vehicle seat. Lock the
vehicle belt. Refer to vehicle owner’s manual
for instructions. If you cannot lock the vehicle
belt, you must use the provided locking clip.
Tension the vehicle belt as much as possible,
checking that it is not loose or twisted.
Check Installation
Blue line must be level with ground.
Vehicle belt must be buckled, tight and
must stay locked.
Child restraint should be stable and not move
side to side more than 1 inch at belt path.
1
2
3
4
5
6
45PIPA instructions44 PIPA instructions
To Next Page
Loading...
