Locking Clip Use
If you determine that you need to use a locking clip,
tighten the buckled belt by pushing down hard on
the infant child restraint and pulling hard on the
shoulder belt.
While pushing down on child restraint, pinch the
two straps together behind the buckle tongue.
Unbuckle the vehicle belt without allowing it to slip.
1 - Connect lap and shoulder belts with locking
clip.
2 - Reroute vehicle belt if necessary. Check that
lap belt does not move by pulling and pushing
hard on infant restraint. If belt loosens or
lengthens, repeat procedure.
The locking clip should be 1/2 inch (12.5 mm)
from the vehicle buckle.
Installation in an Aircraft
Position child restraint so that child is facing the
aircraft seat back.
3 - Route the aircraft lap belt under both lap belt
guides and buckle.
4 - Adjust the angle of the child restraint. A rolled
up towel or blanket may be used to help adjust
the amount of recline (1). The angle is correct
when the blue line is level with the floor of the
aircraft (2).
Tighten the aircraft belt while pushing the child
restraint firmly into the seat.
1/2 in
(12.5 mm)
1
2
1
2
3
4
46 PIPA instructions 47PIPA instructions
To Next Page
Loading...
