Nuna rebl - Height Adjustment

EN
47
2 Rearward facing mode assembled as
(13)
The ISOFIX connectors must be attached and locked onto
the ISOFIX anchor points. (13)-1
The load leg must be installed correctly with green indicator.
(13)-2
Height Adjustment
for Head Support and Shoulder Harnesses
Check that Shoulder Harness Straps are set at the proper height.
Shoulder Harness Straps must be at a height nearest to your
childs shoulders (14), but not above the shoulder line. (15)
If the Shoulder Harness Straps are not at the proper height, the
child might be ejected the child restraint if there is a crash.
Squeeze the head support adjustment lever
(16), while pulling
up or down on the head support until it snaps into one of the 7
positions. The head support positions are shown as (17)
Securing Child
After the child is placed into the seat, check whether the Shoulder
Harness Straps are at proper height.
1 While pressing the adjustment button located at the front of the
child restraint, pull the two Shoulder Harness Straps of the child
restraint.
(18)