55
Vehicle Fitting
Information
The child restraint with base is classified for “Semi-Universal” or
ISOFIX child restraint system use. It is suitable for fixing into the seat
positions of most cars. The letters on the diagram below correspond
with the vehicle fitting positions listed in the following pages.
Seat positions in other cars may also be suitable to accept the child
restraint. If in doubt, consult either the child restraint manufacturer or
the distributor.
DO NOT install this child restraint on the front vehicle seats.
NEVER install this child restraint on any vehicle seat equipped with
safety airbags when used with baby mode.
If your child restraint can be fitted, it is marked with
If your child restraint cannot be fitted, it is marked with
If your vehicle is not listed in this manual or it is not marked with
either a or then please refer to your vehicle’s handbook or
contact the manufacturer for further information.
To Next Page
