Nuna royl - Booster Mode (Without Built-In Harness)

EN EN
Booster Mode (without built-in harness)
Make sure the harness and harness buckle are
stored inside the seat.
With the booster installed in the vehicle, have the
child sit in the booster with their back flat against
the booster seat back.
1 - Route the vehicle belt across the child’s chest
and through the booster lap belt path toward
the vehicle buckle.
2 - Secure the vehicle buckle and listen for a
“click.” Pull up on vehicle belt to remove slack.
3 - Route the vehicle shoulder belt through the
shoulder belt guide.
4 - Adjust the head support. The correct head
support height is obtained when the vehicle
shoulder belt is:
• between the child's neck and shoulder
• flat across the center of the child's chest.
Bottom of head support will be approximately
even with the top of child's shoulders.
The vehicle shoulder belt MUST:
• route completely through the guide
• lie between the child's neck and shoulder
• not fall off the child’s shoulder
The vehicle lap belt MUST lie flat and snug
across the child's thighs.
click
56
3
2
57
1
4
ROYL
™
instructions ROYL
™
instructions