Nuna royl - Vehicle Compatibility

EN EN
10 ROYL
™
instructions 11ROYL
™
instructions
Refer to your vehicle owner’s manual to determine
if your vehicle is equipped with UAS, and how to
correctly use UAS to install this child restraint in
your vehicle.
UAS and Tether Locations
Common locations of UAS and tether in a vehicle
are shown below (consult your vehicle owner’s
manual). Other locations of the tether are shown
on the next page.
UAS in Harness Mode (Forward Facing)
This child restraint is designed to be used with UAS
anchors at the standard spacing of 28 cm (11 inches).
UAS anchor points are defined as 28 cm (11 inches)
from the center of one UAS anchor to the center of
another UAS anchor.
WARNING: DO NOT USE the UAS anchor
belt to attach this child restraint forward facing
with harness mode when restraining a child
weighing over 18 kg (40 lbs).
Vehicle Compatibility
This child restraint can ONLY be installed on vehicle
seats that face forward. DO NOT install in seats that
face to the sides or rear of the vehicle.
IMPORTANT: According to accident statistics,
children are safer when properly restrained in the rear
seating positions than in the front seating positions.
Using UAS
This Child Restraint can be installed without vehicle
belts, by connecting the Restraint’s Universal Anchor
Belts to the lower anchorages in your vehicle.
UAS (Universal Anchorage System) is a system
for installing a child restraint in a vehicle without
using the vehicle belts.
WARNING: You MUST read and understand
ALL child restraint related instructions and
warnings in your vehicle owner’s manual to
correctly and safely use this child restraint in
your vehicle.
Vehicle Tether
Anchor Points
Vehicle Lower
Anchor Points
(UAS)