Nuna royl - Booster Mode Installation (Without Built-In Harness)

EN EN
Booster Mode Installation
(without built-in harness)
At least 4 years old 18–54.4 kg (40–120 lbs),
96–144.8 cm (38–57 in.) tall
Booster Setup
1
- Harness MUST be stored when using the
child restraint as a booster. Raise headrest and
store harness straps and harness buckle inside
the seat.
2 - Place child restraint forward facing in a
compatible vehicle seat that has both a lap belt
and a shoulder belt. The bottom of the restraint
should be parallel to the vehicle seat bottom
and the top of the restraint should contact the
vehicle seat back. The leg rest MUST NOT be
above the restraint seating surface.
3 - Select desired booster recline position 1–4.
Adjust or remove the vehicle headrest as needed
to remove interference. If you remove your
vehicle headrest, be sure to store it in a secure
place; check your vehicle owner’s manual.
4 - Open seat cover.
Complete installation with the lower anchor belt
(p.50) or, if necessary, without (p.52).
Move leg rest to desired installation position.
18 kg
(40 lbs)
54.4 kg
(120 lbs)
Booster
46
1
2
47
3
4
1
2
3
4
ROYL
™
instructions ROYL
™
instructions