Nuna royl - Page 24

EN EN
Using Vehicle Lap Belt
1 - Route vehicle lap belt through forward facing
belt path and buckle vehicle lap belt. (1) Vehicle
belt MUST be routed under True Tension
™
door.
Remove all slack from the vehicle lap belt to
properly secure the child restraint (2).
Close True Tension
™
door (3). Lock vehicle
belt (refer to vehicle owner's manual). Test by
pulling on lap belt to ensure it is locked.
Replace seat cover.
2 - Attach tether hook to tether anchor on vehicle.
3 - Tighten by pulling on tether strap to remove
all slack.
Tuck excess webbing behind child restraint.
To reopen True Tension
™
door, unbuckle vehicle
belt and lift door release button.
Check Installation
Seat is securely installed. Hold seat near belt path
and move seat side to side, front to back, and up
and down. Seat should move less than 2.5 cm
(1 inch).
Tether is properly used and attached to vehicle
tether anchor.
WARNING: Check that child restraint is
securely installed before each use.
2
1
44
1
45
2
3
3
ROYL
™
instructions ROYL
™
instructions