Nuna royl - Page 23

EN EN
Using UAS
1
- Remove UAS belt from storage compartment
and route through forward facing belt path. Belt
MUST be routed under True Tension
™
door.
2 - Lengthen UAS belt as necessary and attach to
lower anchor points in vehicle.
3 - Remove all slack from lower anchor by pulling
loop at end of belt straight back from lower
anchor connector (1).
Close True Tension
™
door (2). Replace seat cover.
4 - Attach tether hook to tether anchor on vehicle
and tighten.
Tuck excess webbing behind child restraint.
To reopen True Tension
™
door, release tether and lower
anchors. If needed, slightly push child restraint against
vehicle seat to relieve tension on lower anchor belt
before releasing anchors. Lift door release button.
Check Installation
Seat is securely installed. Hold seat near belt path
and move seat side to side, front to back, and up and
down. Seat should move less than 2.5 cm (1 inch).
Tether is properly used and attached to vehicle
tether anchor.
WARNING: Do not install by this method for
a child weighing more than 18 kg (40 lbs).
4
42
WARNING: Check that child restraint is
securely installed before each use.
1
2
3
43
1
2
ROYL
™
instructions ROYL
™
instructions