Nuna royl - Page 22

EN EN
Using Vehicle Lap/Shoulder Belt
(preferred installation method)
1 - Route vehicle lap/shoulder belt through forward
facing belt path and buckle vehicle lap/shoulder
belt (1). Vehicle belt MUST be routed under True
Tension
™
door.
Remove all slack from the vehicle belt (2).
Close True Tension
™
door (3). Lock vehicle belt
(refer to vehicle owner's manual). Test by pulling
on shoulder belt to ensure it is locked.
Replace seat cover.
2 - Attach tether hook to tether anchor on vehicle.
3 - Tighten by pulling on tether strap to remove
all slack.
Tuck excess webbing behind child restraint.
To reopen True Tension
™
door, unbuckle vehicle belt
and lift door release button.
Check Installation
Seat is securely installed. Hold seat near belt path
and move seat side to side, front to back, and up
and down. Seat should move less than 2.5 cm
(1 inch).
Tether is properly used and attached to vehicle
tether anchor.
WARNING: Check that child restraint is
securely installed before each use.
2
1
40
1
2
3
41
3
ROYL
™
instructions ROYL
™
instructions