NUTOOL NCS185 - Technical Specifications; Electrical Specifications; Cutting Capacities; Blade and Noise Levels

22
GB
correctly.
Take note of the position of the inner flange, if this should fall
offitmustbereplaceasshownin(Pic.15.).Removeanywood
debrisfromaroundthemotorspindleandthetwoflanges.
Fitthenewbladeasshownin(Pic.16)ensuringthatthedirection
of rotation arrow on the blade corresponds with the direction of
rotationarrowonthefixedguard.Replacetheretainingflange
andbladebolt.
Tightenthehexsocketscrewsecurelybutdonotovertighten.
NOTE: Check the tightness of the hex socket screw before,
duringandaftereachuse.
Take up the tension on blade guard and remove the piece
ofwood or screwdriverthatis holding itintheopen position.
Slowlyreleasetheguardsothatitcoverstheblade.
Check the operation of the blade guard making sure that it
operatescorrectly.Theoperationiscompleteandyourmachine
isreadyforuse.
TECHNICAL SPECIFICATION
Voltage 230-240V~50Hz
Motor 1200W
No load speed 4500min
-1
MaxCut90° 65 mm
MaxCut45° 44 mm
Blade size 185mmx(bore)20mm
Sound Pressure Level L
PA
94,0dB(A)
Sound Power Level L
WA
105,0dB(A)
Vibration Level
Mainhandle:
Auxiliaryhandle:
a
h
=2,215m/s
2
K=1,5m/s
2
a
h
=1,911m/s
2
K=1,5m/s
2
Weight 4,2kg