NUVE NB 9 - Page 16

16
See that second LED flashes in the time display,
again push the encoder button.
See the parameter flashing on the time display.
By turning the encoder button set operating time
value (01 minute to 99 hours 54 minutes or Hold).
Push the encoder button and save set value. See
'dLY' in the temperature display.
By turning the encoder button set operating delay
time value. If 'Off' is selected, heating will start
without delay. If any numerical value is selected;
After pressing Start, it starts heating after the set
delay time (01 minute to 99 hours 54 minutes).
.
Push the encoder button and save set value.
Push ‘the start button’ and start the program.