YOU CAN PRINT
PREVIOUS PROGRAM
OR
ADJUST PRINTING
SETTINGS
PREV PRNT EXIT
Press “F1” key that corresponds to “PREV” expression the window below will be displayed.
1.Prog: 19/01/06 11:30
CONNECT THE PRINTER
THEN PRESS F1 TO
START
START SET EXIT
Press “F3” key below “SET” expression you observe the following window.
LOGGING INTERVAL
01 MIN
EXIT
Logging interval can be selected by using “TAB” key and the value can be changed between
1 minute and 60 minutes by using “INCREASE – DECREASE” keys. After adjusting the
parameter, you can save the changes to memory by pressing “ENTER” key. You will see the
previous window again.
1.PROG: PLASTICS
PRESS F2 TO STOP
PRINTING
STOP SET EXIT
You can stop printing by pressing “F2” key below “STOP” expression. Then following
window appears,
15
To Next Page
Loading...
