The next window permits to set the time.
SET THE TIME
HOUR: MINUTE
999:59
EXIT
“TIME” can be adjusted between 0 to 999 hours 59 minutes or as “HOLD” position. At
“HOLD” position, program works until the stop key pressed manually. The parameters are
selected by using “TAB” key and selected parameter can be changed by using “INCREASE –
DECREASE” keys. After setting the parameters;
- Save the changes in memory by pressing “ENTER” key
- or Pass to the next window without saving the changes by pressing “NEXT” key.
- or Pass to the previous window without saving the changes by pressing “BACK” key.
The next window shows the temperature and humidity values of the next step to set. After
setting the parameters of the 9
th
step if the “ENTER” or “NEXT” key is pressed the window
returns to the stand-by position.
Every program has 9 steps, only the program zero has 1 step.
If you would like to leave the programming press “F1” button below “EXIT” on the display at
any time when “EXIT” appears.
After setting the program as explained, press “START” key to start operation. While the
program is running it is possible to observe the set value of the relevant step on the display by
pressing “F1” below the “SET” expression.
1.PROG: ABCABCABCA
DUE: 001:05
SET REC PT100 HELP
The observation window returns by pressing this key again.
Note: For 9-step programs, you can provide to pass any step without working when you set
the time of that step as “0” but you should enter the time of the first step.
4.4.4. Printer Settings
While the window is on stand-by position, if you press “F2” key below “REC” expression to
reach printer settings the window below will be displayed.
14
To Next Page
Loading...
