NUVE TK 252 - Pt 100 Display; Illumination Settings

1.PROG: PLASTICS
PRINTING
STOPPED
START SET EXIT
On this window, press “F1” key to start printing or press “F3” key to set the printing interval
or press “F4” key to turn back previous window.
4.4.5. PT 100 Display: While PT-100 expression is present above “F3” key, it is possible to
observe the temperature of PT-100 sensors on the display after pressing the “F3” key.
PT-CHAMBERC PT-RHC
24.8C 22.1C
EXIT
Press F3 button to turn back to the previous window.
4.4.6. Illumination Settings
When the illumination control key on the control panel is pressed during stand-by position or
while the program is running the following window appears on the LC display,
WELCOME TO
ILLUMINATION CONTROL
LIGHT IS OFF
START SET EXIT
Press “F3” key that corresponds to “SET” expression the window below will be displayed.
TIME 1
START 00:00
STOP 00:00 OFF
TIME 2
START 00:00
STOP 00:00 OFF
DOOR OPEN OFF
EXIT
16