NuWave MOSAIC - Fcc Information

nuwavenow.com | 13
TROUBLESHOOTING GUIDE
IMPORTANT - FCC Information:
Changes or Changes or modications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
consumer ISM equipment, pursuant to Part 18 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that the interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio TV technician for help.
Note: The device complies with part 18 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may
cause undesired operation.
When the Wok is off of the Nuwave Precision Induction Wok
Initial Single beep
“F” or “C” or
“Sear” or “:”
not ashing
After returning the Wok to
the surface of the Nuwave
Precision Induction Wok, it will
automatically resume cooking.
<10 seconds None
“F” or “C” or
“Sear” or “:”
not ashing
11-70 seconds Yes E1
Resume cooking by pressing
START.
After 70 seconds None 0 Cooking stops.